Re: Bell Swap questions....


[ Follow Ups ] [ Post Followup ] [ TubeNet BBS ] [ FAQ ]

Posted by js on March 22, 2002 at 09:10:41:

In Reply to: Bell Swap questions.... posted by Jay on March 22, 2002 at 08:19:00:

If someone can find a large upright bell - say - with a ruined and even perhaps torn flare, a good repair-guy could cut a section out of the stack that would match up with the male collar on the small end and the small end of the bell flare section on the other end.

This would re-use the original bell flare and collar, but convert it to "upright", using a straight section in between.

Otherwise, someone could shop for a complete and intact upright bell section that would solder into the bottom bow.



Follow Ups: