Posted by Kenneth Sloan on February 11, 2004 at 14:56:21:
In Reply to: Re: Where can I get parts for this? posted by Alex C on February 11, 2004 at 14:42:36:
"The 'hard' part (if I remember correctly) was tapping the Uniballs and threading the brass rod to screw into the Uniballs. It didn't take longer than a day. I have also used plastic ball and sockets so that I didn't have to tap, just screw the threaded rod in. Less than $15 for the whole setup."
What hourly rate do you bill at? One day for $15 seems awfully cheap!